Get STP Status
Command Name | port get STP Status |
Description | Displays the Spanning Tree Protocol Status on a given port. |
Syntax | port get stpstatus |
Parameters |
|
| port number (1 ~ 26) |
Examples | |
| Stp state of [6] port is : [Forward] |
NOTES | STP states include: Listening, Learning, Blocking, & Forwarding |
Get Back Pressure |
|
Command Name | port get backpressure |
Description | Displays the backpressure information on a given port number (enabled or |
| disabled). |
Syntax | port get backpressure |
Parameters |
|
| port number (1 ~ 24) |
Examples | |
| Back Pressure is DISABLED |
NOTES | Check whether |
Get PVID |
|
Command Name | port get pvid |
Description | Displays a given port‟s |
Syntax | port get pvid |
Parameters |
|
| port number (1 ~ 26) |
Examples | |
| PVID of port 6 is 4. |
NOTES | Check whether |
Clear Counters |
|
Command Name | port clear counters |
Description | Clears all the numbers in the counters for a given port. These are counters |
| for RX bytes and TX bytes and so on. |
Syntax | port clear counters |
Parameters |
|
| port number (1 ~ 24) |
Examples | |
| Counters of Port[6] are : [cleared] |
NOTES | This will clear all data in the port specific counters. This data cannot be |
| recovered after this step. |
Clear Intruder Log |
|
Command Name | port clear intruderlog |
Description | This command will clear all intruders out of the intruder log. |
Syntax | port clear intruderlog |
Parameters | None |
Examples | |
NOTES | This will clear all data from the intruder log. This data can not be |
| recovered after this step. |
(Revised | page 114 of 145 |