N-Tron 9000 user manual System Configuration Commands

System Configuration Commands

Set Mode IP config

Command Name	system set modeipconfig
Description	To set the IP address mode of the system
Syntax	system set modeipconfig <manualdhcpbootp>
Parameters	manual
	Uses a static IP address scheme (default mode)
	dhcp
	Pulls an IP address from a DHCP server on the LAN
	bootp
	Pulls an IP address from a Bootp server on boot up
Example	N-TRON/Admin#[1]> system set modeipconfig dhcp
NOTES	Bootp is an older version of DHCP, DHCP is recommended for a
	dynamic address scheme.
Set IP/Subnet/Gateway Addresses of the system
Command Name	system set ip
Description	To set the IP address of the system
Syntax	system set ip <IP-address> <subnet>[ <gateway>]
Parameters	IP Address
	The IP address of the system in dotted decimal notation
	Subnet
	The subnet of the above specified IP Address
	Gateway
	The gateway address of the system.
Example	N-TRON/Admin#[1]> system set ip 10.1.1.158 255.0.0.0
	N-TRON/Admin#[2]> system set ip 10.1.6.150
	255.255.255.0 10.1.6.150
NOTES	The IP address should be a valid IP address (excluding Class D & Class
	E type)
Get IP Address of the system
Command Name	system get ip
Description	To display the IP/Subnet/Gateway addresses of the device
Syntax	system get ip
Parameters	None
Example	N-TRON/Admin#[1]> system get ip
NOTES
Set System Name
Command Name	system set sysname
Description	To set the system name
Syntax	system set sysname <Name-of-the-system>
Parameters	Name-of-the-system
	The system name to be used
Example	N-TRON/Admin#[1]> system set sysname N-Tron
	N-TRON/Admin#[2]> system set sysname “N-Tron Switch”
Notes	Please ensure to use “ “ for supplying arguments with spaces
Get System Name
Command Name	system get sysname
Description	To display the name of the system
Syntax	system get sysname
Parameters	None
Example	N-TRON/Admin#[1]> system get sysname
	System Name	: N-TRON Switch
Notes

(Revised 2010-7-2) page 98 of 145