N-Tron 9000 user manual Ports - Trunking, Continued…, page 37 of

Ports – Trunking, Continued…

Once the Trunk Group is created you will see detailed information for that trunk group, but it should have a disabled state by default.

In order to enable the Trunk Group you need to click on the State Button above. The following page should load asking for the Trunk ID and what the Trunk State is.

NOTE: RSTP must be disabled in order to use the Trunking Feature.

N-Ring Managers cannot have trunking enabled.

A maximum of 4 ports of the same speed can constitute a valid trunk.

Only 1 Trunk per switch can be created.

All trunk ports must be at the same speed and duplex mode. If a port is not linked, there could be difficulty as to similar speed and duplex mode. It is best to

hard code speed and duplex mode for each trunking link, at both ends.

(Revised 2010-7-2) page 37 of 145