N-Tron 9000 Trunk related commands, Enable or Disable Trunking, Modify Trunk, Create Trunk

Trunk related commands

Enable or Disable Trunking

Command Name	trunk set <enable disable>
Description	To enable or disable the trunk that is already created.
Syntax	trunk set enable
	trunk set disable
Parameters
Examples	N-TRON/Admin#[1]> trunk set enable
	Trunking is activated.
	N-TRON/Admin#[1]> trunk set disable
	Trunking is deactivated.
NOTES	RSTP must be disabled in order to use Trunking. All trunk ports must be at
	the same speed and duplex mode. It is best to hard code speed and duplex
	mode for each trunking link, at both ends.
Modify Trunk
Command Name	trunk modify
Description	To add new required ports to the trunk in order to withstand high traffic.
Syntax	trunk modify <port-list> [-name <trunk-name>]
Parameters	port-list
	Port numbers to be in the trunk.
	trunk-name
	Name given to a trunk
Examples	N-TRON/Admin#[1]> trunk modify 1-4 -name trunk1
NOTES	A maximum of 4 ports can be in a trunk. All trunk ports must be at the
	same speed and duplex mode. If a port is not linked, there could be
	difficulty matching similar speed and duplex mode. It is best to hard code
	speed and duplex mode for each trunking link, at both ends.
Create Trunk
Command Name	trunk create
Description	To create a trunk. A trunk is used to get more bandwidth to withstand high
	traffic.
Syntax	trunk create <port-list> [-name <trunk-name>]
Parameters	port-list
	Port numbers to be added to the trunk.
	trunk-name
	Name given to a trunk
Examples	N-TRON/Admin#[1]> trunk create 4-7 –name trunk1
NOTES	RSTP must be disabled in order to use Trunking. Only 1 trunk can be
	created per switch. A maximum of 4 ports can be in a trunk. All trunk
	ports must be at the same speed and duplex mode. If a port is not linked,
	there could be difficulty matching similar speed and duplex mode. It is best
	to hard code speed and duplex mode for each trunking link, at both ends.

(Revised 2010-7-2) page 115 of 145