Napco Security Technologies XP-400 Pager Programming, Telephone Number 1 Programming

(3)Panic - Program to activate the PGM on a Panic alarm.

(4)Test Timer - Program to activate the PGM during a Test Timer report.

[25]Programmable Output Features 3

(1)AC Fail - Program to activate the PGM on the loss of AC. (15 minute delay)

(2)Low Battery - Program to activate the PGM on a Low Battery condition.

(3)*Trouble - Program to activate the PGM on a Trouble condition.

(4)Armed - Program to activate the PGM when the panel is Armed. The PGM output will flash when the panel has gone into alarm.

*Includes Bell Cut, Receiver Fail-to-

Respond, Receiver Tamper and Receiver

JAM.

[26]Miscellaneous Features 2

(1)Momentary Keyswitch Arming - Typically, connect a normally-open Keyswitch across the zone AND its 3.3K zone-doubling resistor.

(2)Reserved.

(3)Inhibit Fail-to-Communicate Display - This option prevents the keypad from either indicating or sounding when a Fail to Communicate has occurred.

(4)Inhibit Low Battery Display - Program to inhibit the Low Battery Display at the keypad. Low Battery Reporting is not inhibited. The programming option is not permitted for UL installations.

Telephone Number 1 Programming

[30]Subscriber ID Number

For 4/2 format enter a 4 digit number. If 3/1 format is required, enter a 3 digit number, then press the i key to blank the last digit.

[31]Telephone Number 1

Program the phone number to be dialed for Telephone Number 1. Program the number directly, just as it is entered on a TouchTone phone. A fixed Dial Tone Detection (E) is included prior to the Dialing Prefix (Block Number 44). Programming an E is

not required for Telco 1, Telco 2 and Telco

3.If dial tone detection is not desired select No Dial Tone Detection in Communicator Features [46-1]. Use the i key to blank

out remaining digits in the phone number.

[32]Receiver Format

Select the receiver format to be used to report for Telephone Number 1: Program a 0 to disable reporting to Telco 1.

[0]	Disabled	[4]	Universal High Speed
[1]	Ademco Slow	[5]	Reserved
[2]	Radionics Slow	[6]	Point ID
[3]	Silent Knight Fast	[7]	Pager

Pager Programming

If Pager Format ([32]and/or[42]and/or[52] =

7)is selected, pager data will be displayed as shown in Figure 7. If Pager Format is selected 4/2 format must be programmed and Sumcheck is not permitted. If a PIN number is required refer to Pager Extend [33-4].

15