Napco Security Technologies XP-400 User Program Mode, From the Keypad, Using A Keyfob GEM-KF

Full Setting the System with Automatic Bypassing - Home/Away with Delay Zones

From the Keypad

Press C B to return protection to

Home/Away with Delay Zones that have

been automatically bypassed. Three minutes are allowed to walk through Exit/ Entry and Exit/Entry Follower Zones.

Using A Keyfob (GEM-KF)

All zones in the system can be armed regardless of the state of the Exit/Entry Zone when arming with a Keyfob and using an AUX key programmed as Full Set. Press Kand press and hold the Mor N

keys for 1.5s when leaving the premises. All zones, including Home/Away Zones are armed.

Bypassing a zone

Press the Ckey, then the zone number to be bypassed. While the panel is DISARMED, the

bypassed zone LED will flash slowly; indicating the zone has been bypassed. While the panel is ARMED, the bypassed zones will only be displayed if the Display Bypassed [21-3] option has been selected.

Unbypassing a zone (Disarmed only)

Press the C key then the number of the zone to be unbypassed.

Group Bypass

Press CC to Bypass all Exit/Entry

Follower Zones [02] or Home/Away Zones

[01](only if the system is programmed exclusively for Home/Away with Delay zones).

Using A Keyfob (GEM-KF)

Hold the Mor N key on the Keyfob to

Bypass all Exit/Entry Follower Zones [02] or Home/Away Zones [01] (only if the system is programmed exclusively for Home/Away with Delay zones).

User Program Mode

To prevent the loss of the User 1 Code, the panel default program includes User 1 Code Lockout [96-2].

To change the User 1 Code from its default value of 1234, program the 4-digit User 1 Code through Dealer Programming [95]. User 1 Arm/ Disarm code is also used to program User Codes 2 - 4. By default, the User 1 code cannot be re-programmed by the user.

If it is necessary to change the User 1 code, it can be changed through downloading or Dealer keypad programming. From Dealer Program Mode, change the User 1 Code Lockout ([96-2] LED=OFF) to disabled.

Entering User Program Mode

1. Enter A8

2. Enter User 1 Code

(1234)

(Default)

9