WI1370
000 |
Leading Digits |
Report Code |
Subscriber ID Number |
FIGURE 7 DEFAULT PAGER DISPLAY
Pager Alarm data is the same as 4/2 format with the exception that the 2 digit Report Code is transmitted before the 4 digit Subscriber ID.
[33]Receiver Options
(1)2300 Hz HS/Kissoff - Select 2300 Hz Handshake and Kissoff.
(2)Sumcheck - Only used for the following Receiver Formats: Ademco Slow, Radionics Fast, Silent Knight Fast and Universal High Speed. This is a sophisticated data format used to enhance the speed and check the accuracy of the received transmission. This format should be used whenever the central station has this capability. Instead of sending a second round to verify correct data, the panel sends a Sumcheck digit after sending the Subscriber ID and Alarm Code.
(3)Single Digit - 3/1 Format.
(4)No Handshake/Pager Extend - The meaning of this option is dependent on Receiver Format programming.
No Handshake (All receiver formats except Pager
Format)
If programmed no Handshake is required.
Pager Extend (Pager Format Selected)
Pager PIN Number - Program if a PIN number is required by the paging system. The digits in Telephone Number 2 will be added on to telephone number 1 and/or telephone number 3 allowing for a total of 24 digits. See sample program below. Note: If selected do not program backup reporting.
If a
[31]- Pager Telephone number
[32]- Select Pager Format
[33] - Select Pager Extend
[41]- D D D X X X X X X X C 0
Delay | Leading 0 |
PIN Number | Terminating Digit (#) |
Pager display will appear as shown in Figure 7 except there will be only one leading 0.
[34]Zone Report, Telco 1
Select zone(s) required to send an alarm report to Telephone Number 1.
[35]Zone Restore Report, Telco 1
Select zone(s) required to send a restore report to Telephone Number 1. The zones will send a restore after Bell
[36]System Reporting, Telco 1
(1)Keypad Panic 2 - Program to activate a Keypad Panic 2 report (KK).
(2)AUX/AMBUSH - Program to activate an AUX or AMBUSH report (ff).
(3)Panic - Program to activate a Panic report (gG).
(4)Test Timer - Program to activate a Test Timer report.
16