Napoleon Fireplaces BGD36CFNTR Table Of Contents, Please Retain This Manual For Future Reference

2

TABLE OF CONTENTS

PG 4-5	INTRODUCTION
	Warranty
	General Instructions
	General Information
	Care of Glass & Plated Parts
	Unit Dimensions
	Installation Overview
6-19	VENTING
	Venting Lengths
	Minimum Air Terminal Location Clearances
	Typical Minimum and Maximum Vent Lengths
	Special Vent Installations
	Venting Application Flow Chart
	Venting Specifications
	BGD36CF(G) Pre-Installation Preparation
	Removing the Valve Access Door
	Door Operation
	Rear Exit
	Top Exit
19-29	INSTALLATION
	Wall and Ceiling Protection
	Horizontal Installation
	Adjustable Firestop Installation
	Vertical Installation
	Using Flexible Vent Components
	Using Rigid Vent Components
	Restricting Vertical Vents (BGD42CF ONLY)
	Gas Installation
	Optional wall switch installation excluding BGD36CFG
	Mobile Home Installation
	Framing
	Installing Standoffs
	BGD36CF(G) Minimum Mantel and Enclosure Clearances
	Clean Face Surround Minimum Enclosure Clearances
	Optional Clean Face Surround Installation BGD36CF(G) only
	Finished Floor Installation
	Hearth Installation
	Optional Clean Face Trim Kit Installation
	BGD42CF Minimum Mantel and Enclosure Clearances
30	BGD36CF FINISHING

Log Placement

Glass/Door Replacement

30-31	BGD42CF FINISHING
	Door Installation / Removal
	Removing Valve Access Door
	Glass/Door Replacement
	Door Trim
	Grate Installation
	Log Placement
32	COMMON FINISHING
	Glowing Embers
	Charcoal Embers
	Vermiculite
	Charcoal Lumps (BGD42CF Only)
	Logo Placement
32	BGD36CFG FINISHING
	Glass Burner Installation
	BGD36CFG bulb replacement
	BGD36CFG lens assembly replacement
33	OPTIONAL BLOWER INSTALLATION

BGD36CF Accessing the Blower

BGD42CF Accessing the Blower

Installing the Blower

34OPTIONAL FAN INSTALLATION

GD36 THERMOSTATIC SENSOR CONTROL

35BGD36CFG BURNER SWITCH/WIRING DIAGRAM

36BGD36CFG LIGHT SWITCH/WIRING DIAGRAM

37RECEPTACLE WIRING DIAGRAM

38OPERATION BGD36CF AND BGD42CF

Operating Instructions

Maintenance

39OPERATION / MAINTENANCE BGD36CFG 40-41 ADJUSTMENTS

Pilot Burner Adjustment

Venturi Adjustment

BGD36CFG Venturi Adjustment

Flame Adjustment

42-44 COMMON REPLACEMENTS BGD36CF(G) REPLACEMENTS BGD42CF REPLACEMENTS

45-48 TROUBLE SHOOTING GUIDE

47SERVICE HISTORY

48NOTES

PLEASE RETAIN THIS MANUAL FOR FUTURE REFERENCE

!WARNING

•Do not burn wood or other materials in this fireplace.

•Adults and especially children should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition. Supervise young children when they are in the same room as the fireplace.

•Clothing or other flammable material should not be placed on or near the fireplace.

•Due to high temperatures, the fireplace should be located out of traffic and away from furniture and draperies.

•Ensure you have incorporated adequate safety measure to protect infants/toddlers from touching hot surfaces.

•Even after the fireplace is out, the glass and/or screen will remain hot for an extended period of time.

•Check with your local hearth specialty dealer for safety screens and hearth guards to protect children from hot surfaces. These screens and guards must be fastened to the floor.

•Any safety screen or guard removed for servicing must be replaced prior to operating the fireplace.

•It is imperative that the control compartments, burners and circulating blower and its passageway in the fireplace and venting system are kept clean. The fireplace and its venting system should be inspected before use and at least annually by a qualified service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding material, etc. The fireplace area must be kept clear and free from combustible materials, gasoline and other flammable vapours and liquids.

•Under no circumstances should this fireplace be modified.

•This fireplace must not be connected to a chimney flue pipe serving a separate solid fuel burning appliance.

•Do not use this fireplace if any part has been under water. Immediately call a qualified service technician to inspect the fireplace and to replace any part of the control system and any gas control which has been under water.

•Do not operate the fireplace with the glass door removed, cracked or broken. Replacement of the glass should be done by a licensed or qualified service person.

•Do not strike or slam shut the fireplace glass door.

•This fireplace uses and requires a fast acting thermocouple. Replace only with a fast acting thermocouple supplied by Wolf Steel Ltd.

•Pressure relief doors must be kept closed while the fireplace is operating to prevent exhaust fumes containing carbon monox- ide, from entering into the home. Temperatures of the exhaust escaping through these openings can also cause the surrounding combustible materials to overheat and catch fire.

•Only doors / optional fronts certified with the unit are to be installed on the appliance.

NOTE: CHANGES, OTHER THAN EDITORIAL, ARE DENOTED BY A VERTICAL LINE IN THE MARGIN.

W415-0661 / C / 02.20.08