8-40
10. In the case of a long board, slide the bracket to fasten the other edge of the board.
11. Install the top cover to the PCI module.
12. Install the PCI module.
13. Connect the network cable and option cables.
14. Close the release lever.
15. Secure the release lever with the setscrew.
16. Boot the PCI module using the NEC ESMPRO Manager or ft server utility to establish a
dual configuration.
In the initial setting, the server will start up automatically upon mounting the PCI module.
If it is set not to start up automatically, use Data Viewer of NEC ESMPRO Manager or ft
server utility to start it.
For more information, refer to "NEC ESMPRO Agent and Manager" - "Maintenance of
NEC Express5800/ft series" in Chapter 5.
17. Check the PCI module status LED and PCI board status LED.
For description of LED indications, see “LEDs” in Chapter 2 and “Setup of Optional PCI
Board” later in this chapter.
Screw
Bends for fastening
boards