Dual In-Line Memory Modules (DIMMs)120

6Insert the new
DIMM straight down
into the DIMM con-
nector until the
latches snap into
the locked position.
Observe the keyed
side of the DIMM to
align it with the con-
nector. When
seated, the DIMM
stands upright,
firmly in place. If
you cannot snap the
DIMM into place, do
not force it. Reposi-
tion it, making sure
that the bottom of
the DIMM is seated completely in the connector.
7Reinstall the controller board into the printer.
Gently slide the controller board into the printer’s tracks until it is fully
seated, and then tighten the two screws.
8Reconnect all interface cables.
9Reconnect the power cord, and turn on the printer.
5"
In compliance with UL guidelines, “The appliance inlet is consid-
ered to be the main disconnect device.”
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII
................................................ ........................ ..........
................................................ ........................ ..........
................................................ ........................ ..........
................................................ ........................ ..........
IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII IIIIIIIII
................................................ ........................ ..........
................................................ ........................ ..........
................................................ ........................ ..........
................................................ ........................ ..........