Lower Feeder Unit (LFU)142
7Install the envelope feeder
onto the tray as shown.
8Adjust the media guides to the
length and width of the enve-
lopes.
5"
Make sure the guides
are snug enough to
keep the envelopes
straight, but not so tight
that they buckle the
envelopes.
9Place the envelope stack into
the tray with the printing-side up.
10 Slide the media tray back into the printer.
The media tray must be located in the upper position, not in the optional
lower input feeder.
Japanese Postcard Feeder
A postcard feeder allows you to print on standard Japanese-size postcards.
5"
This feeder is available only on the 100 volt model in the upper
media tray.
1In the printer driver (Paper tab, Paper Type option), select Thick Stock.
2On the control panel, press the Media key to select printing on thick stock,
if necessary.
3Place the postcards on a flat surface, and flatten them by pressing down
the corners.
4Flex the postcard stack (including the edges) to remove any stiffness.
5Correct any bent corners, and then tap the postcards on a flat surface to
align them.
6Remove the upper media tray from the printer (and remove any media in
the tray).
The postcard feeder can be installed only in the upper media tray.