PROJECTING AN IMAGE

9. Press the SELECT or button to highlight the [OK] and press the ENTER button.

This completes the keystone correction.

Selecting “Cancel” will return to the adjustment screen without saving changes (Step 3).

Selecting "Reset" will return to the factory default. Selecting "Undo" will exit without saving changes.

NOTE: To return the 3D Reform correction setting values to the factory default, press and hold the 3D REFORM button for a minimum of 2 seconds.

NOTE: During 3D Reform adjustment, "Aspect Ratio" and "Screen" may not be available. Should this happen, first reset the 3D Reform data and then do each setting. Second repeat the 3D Reform adjustment. Changing Aspect Ratio and/or Screen setting can limit 3D Reform in its adjustable range.

The adjustable ranges for 3D Reform are as follows:

Horizontal

Max ±30° approx. (Max ±25° approx. on LT240)

Vertical

Max ±40° approx.

*The following are conditions at the above maximum angle when all of the following are met

Image is projected in Wide (Zoom)

Resolution is XGA

Higher resolution than XGA limits 3D Reform in its adjustable range.

Menu items should be set as follows: Aspect Ratio ........... 4:3

Screen Type ........... 4:3 Screen Position ...... 0

Horizontal and Vertical are adjusted separately.

A combination of both adjustments limits 3D Reform in its adjustable range.

E-47

Page 47
Image 47
NEC LT260 user manual Max ±30 approx. Max ±25 approx. on LT240