NEC NDA-24233 manual Error Response Table, Error Response /2

VisuaLink 128/384 Engineering Guide Error Response Table

4: Error Response Table

If a command input from console is not understandable or has a different configuration, an error response is transmitted to the console. Error responses are shown in the following table.

Table 4-1: Error Response Table (1/2)

ERR Number	Contents	Countermeasures
ERR01	Syntax error.	Check the format of a command
ERR05	It is a command that cannot be	Check current system settings
	accepted by the current system.
ERR06	It is during an initial setting.	Try again
ERR07	Time out	Try again
ERR09	It is a command that cannot be	Check current system settings
	executed in the current mode.
ERR10	A camera is not connected.	Check current system settings
ERR11	This is not a preset camera.	Check current system settings
ERR12	The displayed screen is not a received	Check current system settings
	video, so a remote camera control
	cannot be performed.
ERR16	NEC specific features cannot be	Check current system settings
	performed.
ERR17	The remote terminal has no capability	It is impossible in the current configuration
	to perform this command.
ERR18	Cannot be controlled for it is set for a	VL is in remote maintenance.
	pass-through mode.
ERR20	MLP port has not yet been established.	Check communication status and execute
		command again.
ERR21	Error in data speed setting combination.	Check current system settings
ERR22	The local site is not participating in the	Check communication status
	conference room.
ERR23	A specified conference room is not	Check communication status and execute
	participating in a multi-point	command.
	conference.
ERR24	Multi-point command is either invalid or	Check communication status and execute
	overlapping.	command.
ERR26	VL is not in multi-point conference.	Check communication status and execute
		command.
ERR32	It cannot be set in the current network.	Check communication status and execute
		command.
ERR37	The remote terminal cannot be	Check communication status and execute
	recognized as a NEC model.	command.
ERR38	Local loopback cannot be done since it	Execute a command after release of the
	is processing a remote loopback.	remote loopback.
ERR 40	It is in a telephone communication	Command to execute is impossible.
	mode.
ERR41	Network in use is not an ISDN line.	Check current system settings
ERR42	No incoming call	Check communication status and execute
		command.
ERR43	Currently originating a call.	Check communication status and execute
		command.
ERR44	Incoming call	Check communication status and execute
		command.
ERR45	On line.	Check communication status and execute
		command again.

NDA-24233 Issue 2 Page 4-1