2. Projecting an Image (Basic Operation)

Connecting Your Computer/Connecting the Power Cord

1.Connect your computer to the projector.

This section will show you a basic connection to a computer. For information about other connections, see “6. Installation and Connections” on page 132.

Connect the computer cable (VGA) between the projector’s COMPUTER 1 IN connector and the computer’s port (mini D-Sub 15 Pin). Turn two thumb screws of both connectors to fix the computer cable (VGA).

2.Connect the supplied power cord to the projector.

First connect the supplied power cord’s three-pin plug to the AC IN of the projector, and then connect the other plug of the supplied power cord in the wall outlet.

The projector’s power indicator will flash for a few seconds and then will light orange* (standby mode). The STATUS indicator will also light green*.

*This will apply for both indicators when [NORMAL] is selected for [STANDBY MODE]. See the Power Indicator section.(→ page 192)

COMPUTER 1 IN

Make sure that the prongs are fully inserted into both the AC IN and the wall outlet.

To wall outlet ←

CAUTION:

Parts of the projector may become temporarily heated if the projector is turned off with the POWER button or if the AC power supply is disconnected during normal projector operation.

Use caution when picking up the projector.

13

Page 30 Page 32
Page 31
Image 31
NEC NP-P350X, NP-P420X, NP-P350W  Connecting Your Computer/Connecting the Power Cord, Projecting an Image Basic Operation
Page 30 Page 32
Top Page Image Contents