NETGEAR SRX5308-100NAS Create DMZ WAN Inbound Service Rules

Firewall Protection
151
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
IPv6 DMZ WAN Outbound Service Rules
To create a new IPv6 DMZ WAN outbound rule:
1. In the upper right of the DMZ WAN Rules screen, select the IPv6 radio button. The screen
displays the IPv6 settings (see Figure 79 on page 149).
2. Click the Add table button under the Outbound Services table. The Add DMZ WAN
Outbound Service screen for IPv6 displays:
Figure 81.
3. Enter the settings as explained in Table 32 on page 133. In addition to selections from the
Service, Action, and Log drop-down lists, you need to make selections from the following
drop-down lists:
•DMZ Users
•WAN Users
Unless your selection f rom the Action drop-down list is BLOCK always, you also need to
make selections from the following drop-down lists:
•Select Schedule
•QoS Priority
4. Click Apply. The new rule is now added to the Outbound Services table. The rule is
automatically enabled.
Create DMZ WAN Inbound Service Rules
The Inbound Services table lists all existing rules for inbound traffic. If you have not defined
any rules, no rules are listed. By default, all inbound traffic (from the Internet to the DMZ) is
blocked.
Inbound rules that are configured on the LAN WAN Rules screen take precedence over
inbound rules that are configured on the DMZ WAN Rules screen. As a result, if an inbound
packet matches an inbound rule on the LAN WAN Rules screen, it is not matched against the
inbound rules on the DMZ WAN Rules screen.