NETGEAR SRX5308-100NAS Rear Panel, Bottom Panel with Product Label

Introduction
19
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Rear Panel
The rear panel of the VPN firewall includes a console port, a Factory Defaults Reset button, a
cable lock receptacle, an AC power connection, and a power switch.
Figure 2.
Viewed from left to right, the rear panel contains the following components:
1. Cable security lock receptacle.
2. Console port. Port for connecting to an optional console terminal. The port has a DB9 male
connector. The default baud rate is 115200 K. The pinouts are (2) Tx, (3) Rx, (5) and (7)
Gnd. For information about accessing the command-line interface (CLI) using the console
port, see Use the Command-Line Interface on page 334.
3. Factory Defaults Reset button. Using a sharp object, press and hold this button for about
8 seconds until the front panel Test LED flashes to reset the VPN firewall to factory default
settings. All configuration settings are lost, and the default password is restored.
4. AC power receptacle. Universal AC input (100–240 VAC, 50–60 Hz).
5. A power on/off switch.
Bottom Panel with Product Label
The product label on the bottom of the VPN firewall’s enclosure displays factory default
settings, regulatory compliance, and other information.
Figure 3.
Security lock
receptacle
Console port
Factory Defaults
AC power
receptacle
Power
switch
Reset button