Firewall Protection
142
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Figure 73.
3. From the Default Outbound Policy drop-down list, select Block Always. (By default, Allow
Always is selected.)
4. Next to the drop-down list, click the Apply table button.
To change an existing outbound or inbound service rule, in the Action column to the right of
the rule, click one of the following table buttons:
•Up. Moves the rule up one position in the table rank.
•Down. Moves the rule down one position in the table rank.
•Edit. Allows you to make any changes to the definition of an existing rule. Depending on
your selection, one of the following screens displays:
-Edit LAN WAN Outbound Service screen for IPv6 (identical to Figure 75 on page 144)
-Edit LAN WAN Inbound Service screen for IPv6 (identical to Figure 77 on page 146)
To enable, disable, or delete one or more IPv4 or IPv6 rules:
1. Select the check box to the left of each rule that you want to enable, disable, or delete,
or click the Select All table button to select all rules.
2. Click one of the following table buttons:
•Enable. Enables the rule or rules. The ! status icon changes from a gray circle to a
green circle, indicating that the selected rule or rules are enabled. (By default, when a
rule is added to the table, it is automatically enabled.)
•Disable. Disables the rule or rules. The ! status icon changes from a green circle to a
gray circle, indicating that the selected rule or rules are disabled.
•Delete. Deletes the selected rule or rules.