IPv4 and IPv6 Internet and WAN Settings
38
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
9. Click Apply to save your changes.
10. Click Tes t to evaluate your entries. The VPN firewall attempts to make a connection
according to the settings that you entered.
11. Verify the connection:
a. Select Network Configuration > WAN Settings > WAN Setup. The WAN Setup
screen displays the IPv4 settings (see Figure 14 on page 33).
b. In the Action column, click the Status button of the WAN interface for which you
want to display the Connection Status pop-up screen. (The following figure shows a
PPPoE configuration; the IP addresses are not related to any other examples in this
manual.)
Figure 19.
The Connection Status screen should show a valid IP address and gateway, and you are
connected to the Internet. If the configuration was not successful, see Troubleshoot the
ISP Connection on page 388.
Note: If your ISP requires MAC authentication and another MAC address
has been previously registered with your ISP, then you need to enter
that address on the WAN Advanced Options screen for the WAN
interface (see Configure Advanced WAN Options and Other Tasks
on page 67).