NETGEAR ProSafe 802.11g Wireless Access Point WG302v2 Reference Manual

Warning: Settings updated from the CLI (with get, set, add, and remove commands) will not be saved to the startup configuration unless you explicitly save them by issuing the save-runningcommand.

The get, set, add, and remove commands are followed by one or more keywords and might be followed by one or more optional or required name-value pairs.

You can use CLI commands to view or configure most of the features that you can view and configure by using the Web UI.

Note: CLI commands are not available to merge, import, and export the known AP list for Rogue AP detection feature. Additionally, you cannot set the channel or

frequency by using the CLI.

Using the CLI to Configure the ProSafe 802.11g

This section describes the commands you use to view and configure the WG302v2. The CLI commands correspond to tasks you can accomplish by using the Web-based user interface (UI). In some cases, the CLI get command provides additional details not available through the Web UI.

Command Line Reference

C-5

v1.0, May 2006

Page 87
Image 87
NETGEAR WG302v2 manual Using the CLI to Configure the ProSafe 802.11g