NETGEAR ProSafe 802.11g Wireless Access Point WG302v2 Reference Manual

Viewing and Configuring Management Settings

The commands in Table C-12correspond to the pages on the Web UI under the Management heading. This section includes commands for the following features:

Change Password

Remote Management

Upgrade Firmware

Backup and Restore

Reboot the System.

Table C-12 AP Management

Task

Command

 

 

Set a password for admin access

set system password <password>

to the AP.

 

 

Enable Remote CLI Access

set ssh status up

 

Disable Remote CLI Access

set ssh status down

 

Enable SNMP

set snmp status up

 

Disable SNMP

set snmp status down

 

Set a Public Community name

set snmp ro-community <string>

 

Set a Private Community name

set snmp rw-community <string>

 

Set an IP address to receive

set traphost host <ip_address>

 

SNMP traps

 

 

Upgrade the firmware (requires a

firmware-upgrade <url>

reboot)

Example:

 

firmware-upgrade tftp://1.2.3.4/upgrade.tar

 

firmware-upgrade file://1.2.3.4/tmp/upgrade.tar

 

Backup the configuration file

config download <url>

 

Example:

 

config download tftp://1.2.3.4/

 

defaultcfg.xml

 

Restore the configuration file

config upload <url>

 

Example:

 

config upload tftp://1.2.3.4/defaultcfg.xml

 

Revert to factory default settings

factory-reset

Reboot the system

reboot

 

 

 

 

C-14

Command Line Reference

v1.0, May 2006

Page 96
Image 96
NETGEAR WG302v2 manual Viewing and Configuring Management Settings