NETGEAR ProSafe 802.11g Wireless Access Point WG302v2 Reference Manual
b.Click the Basic Settings link in the Setup section of the main menu to view the Basic Settings menu.
Figure
c.Configure the settings for your network and click Apply. See the online help or “Basic IP Settings” on page
d.Click Wireless Settings in the Setup section of the main menu to view the Wireless Settings menu.
e.Enter the wireless settings and click Apply. See the online help or “Wireless Settings” on page
Note: In the USA, the Region is preset according to regulatory requirements and 
cannot be changed. In other areas, you can and must set the Region. It may not be legal to operate the wireless access point in a region other than one
of those identified in this field.
Now that you have finished the setup, you are ready to deploy the WG302v2 in your network. If needed, you can now reconfigure the computer you used for this process back to its original TCP/IP settings.
3.Deploy the wireless access point.
a.Disconnect the WG302v2 and put it where you will deploy it. The best location is elevated, such as wall mounted, or on the top of a cubicle, at the center of your wireless coverage area, and within line of sight of all the mobile devices. For more information, see “Wireless Equipment Placement and Range Guidelines” on page
b.Lift the antenna on either side to be vertical.
Basic Installation and Configuration |
