NETGEAR WG302v2 manual General Information Fields, Field Description Access Point Information

NETGEAR ProSafe 802.11g Wireless Access Point WG302v2 Reference Manual

Table 3-1describes the fields on the General Information page.

Table 3-1 General Information Fields

Field	Description
Access Point Information
Access Point Name	The name of the access point, which you can configure.
(NetBIOS name)
MAC Address	The Media Access Control address (MAC address) of the wireless
	access point’s Ethernet port.
Country/Region	The domain or region for which the wireless access point is licensed for
	use. It may not be legal to operate this wireless access point in a region
	other than one of those identified in this field.
Firmware Version	The version of the firmware currently installed.
Access Point Mode	The operating mode of the WG302v2: Access Point, Point-to-point
	bridge, Multi-point bridge or Repeater.
VLAN (802.1Q)	Indicates if VLAN support is enabled. The default is enabled.
Current IP Settings
IP Address	The IP address of the wireless access point.
Subnet Mask	The subnet mask for the wireless access point.
Default Gateway	The default gateway for the wireless access point communication.
DHCP Client	If the DHCP Client is enabled, the current IP address was obtained
	from a DHCP server on your network. Disabled indicates a static IP
	configuration.
Current Wireless Settings
Operating Mode	Shows the IEEE 802.11 wireless operating mode.
Channel/Frequency	The channel the wireless port uses. The default channel setting is 11.
	For the frequencies used on each channel, see the resources listed in
	Appendix A, “Related Documents.
Rogue AP Detection	Shows whether Rogue AP Detection is enabled.
Security Profiles	For each Security Profile, the following information is displayed: Profile
	Number, Profile Name, SSID, Security, VLAN, and Status.

3-8 Management and Information

v1.0, May 2006