NETGEAR WG302v2 manual Viewing and Configuring System Information

NETGEAR ProSafe 802.11g Wireless Access Point WG302v2 Reference Manual

Viewing and Configuring System Information

The commands in Table C-12correspond to the pages on the Web UI under the Information heading. This section includes commands for the following features:

•Activity Log

•Available Wireless Station List

•Statistics

•Rogue AP Detection

Table C-13 AP Information

Task	Command
View the SysLog activity log	get log-entry
View all SysLog server information	get log detail
Enable SysLog	set log relay-enabled 1
Disable SysLog	set log relay-enabled 0
Set the IP address of the SysLog server	set log relay-host <ip_address>
Set the port number configured in the	set log relay-port <port_number>
SysLog server
View a list of wireless stations	get association detail
View interface statistics	get interface all ip mac ssid
	tx-packets tx-bytes tx-errors
	rx-packets rx-bytes rx-errors
Turn Rogue AP Detection On	set radio wlan0 ap-detection on
Turn Rogue AP Detection Off	set radio wlan0 ap-detection off
View a list of unknown APs	get unknown-ap
View a list of known APs	get known-ap-config
Add an AP to the Known AP list	add known-ap-config <mac_address>
Delete an AP from the Known AP list	remove known-ap-config <mac_address>
Delete all APs from the Known AP list	remove known-ap-config all

Command Line Reference C-15

v1.0, May 2006