NETGEAR WNR200v4 user manual Static Routes,  To set up a static route

N300 Wireless Router WNR2000v4

Static Routes

Static routes provide additional routing information to your router. Under usual circumstances, the router has adequate routing information after it has been configured for Internet access, and you do not need to configure additional static routes. You have to configure static routes only for unusual cases such as multiple routers or multiple IP subnets located on your network.

As an example of when a static route is needed, consider the following case:

•Your primary Internet access is through a cable modem to an ISP.

•You have an ISDN router on your home network for connecting to the company where you are employed. This router’s address on your LAN is 192.168.1.100.

•Your company’s network address is 134.177.0.0.

When you first configured your router, two implicit static routes were created. A default route was created with your ISP as the gateway, and a second static route was created to your local network for all 192.168.1.x addresses. With this configuration, if you attempt to access a device on the 134.177.0.0 network, your router forwards your request to the ISP. The ISP forwards your request to the company where you are employed, and the request is likely to be denied by the company’s firewall.

In this case you have to define a static route, telling your router that 134.177.0.0 should be accessed through the ISDN router at 192.168.1.100. In this example:

•The Destination IP Address and IP Subnet Mask fields specify that this static route applies to all 134.177.x.x addresses.

•The Gateway IP Address field specifies that all traffic for these addresses should be forwarded to the ISDN router at 192.168.1.100.

•A metric value of 1 works because the ISDN router is on the LAN.

•Private is selected only as a precautionary security measure in case RIP is activated.

To set up a static route:

1. Select Advanced > Advanced Setup > Static Routes. The Static Routes screen displays.

2. Click the Add button.

Advanced Settings

101