NETGEAR WNR3500L-100NAS user manual Connect to Configure Your Wireless Network on

RangeMax™ Wireless-N Gigabit Router with USB WNR3500L User Manual

Table 8-2. Troubleshooting LED Behavior (continued)

Situation	Recommended Action
Power light blinks green slowly	Restore the wireless router firmware:
and continuously. The wireless	1.	Make sure that your PC is connected to your wireless router and
router firmware is corrupted.
		the wireless router is powered on.
	2.	Insert the Resource CD that came with your router into your PC.
		The CD automatically starts and detects the language you are using
		on your PC. Select a different language option, if you prefer. If the
		CD does not automatically start, browse the CD and double-click
		.
	3.	From the CD menu, select Supporting Software, then Netgear
		Firmware Recovery Utility, and follow the prompts for the
		recovery process.
	4.	After firmware recovery is complete, follow the prompts to restore
		your configuration.
	The firmware recovery utility places a Netgear Router Recovery
			shortcut on the desktop.
Internet light stays amber.
	When the router is turned on, the Internet light turns amber for about 60
	seconds and then turns green. If the light does not turn green, the
	router has a problem.
	If the Internet light is still amber 2 minutes after turning on power to the
	router:
	1.	The Internet is not accessible. Confirm that you have the correct
		internet setting.
	2.	Clear the router’s configuration to factory defaults. This will set the
		router’s IP address to www.routerlogin.net. This procedure is
		explained in “Restoring the Default Configuration and Password” on
		page 8-14.
	3.	Turn the power off and back on to see if the router recovers.
WPS push-button blinks green	Check the following:
after setting WPS security.	1.	Make sure that you are using the push-button (see “Using Push ‘N’
		Connect to Configure Your Wireless Network” on page 2-9).
	2.	Check that PIN verification has succeeded for the WPS-enabled
		device you are connecting to the router.
	3.	Make sure you have not pushed the push-button after disabling the
		WPS function (you logged into the router and disabled this
		previously).
	4.	Check that the router is not in the temporary AP setup locked state
		(if you are using the wireless repeater function).

Troubleshooting 8-4

v1.0, November 2009