RangeMax™ Wireless-N Gigabit Router with USB WNR3500L User Manual

The wireless router WPS screen displays a message confirming that the client was added to the wireless network. The wireless router generates an SSID, and implements WPA/WPA2 wireless security if the wireless settings on the router are not configured. The wireless router will keep these wireless settings unless you change them, or you clear the Keep Existing Wireless Settings check box in the WPS Settings screen.

Figure 2-6

6.Note the new SSID and WPA/WPA2 passphrase for the wireless network. You can view these settings on the Wireless Settings screen. See Step 3 of the “Configuring WPA, WPA2, or WPA/WPA2 Wireless Security” section.

To access the Internet from any computer connected to your wireless router, launch a browser such as Microsoft Internet Explorer or Mozilla Firefox. You should see the wireless router’s Internet LED blink, indicating communication to the ISP.

Note: If no WPS-capable client devices are located during the 2-minute timeframe, the SSID and security settings will not be changed.

Using a PIN to Configure Your Network and Add a Client

Any wireless computer or wireless adapter that will connect to the wireless router wirelessly is a client. The client must support a WPS PIN, and must have a WPS configuration utility, such as the NETGEAR Smart Wizard or Atheros Jumpstart.

The first time you add a WPS client, make sure that the Keep Existing Wireless Settings check box on the WPS Settings screen is cleared. This is the default setting for the wireless router, and allows it to generate the SSID and WPA/WPA2 security settings when it implements WPS. After WPS is implemented, the wireless router automatically selects this check box so that your SSID and wireless security settings remain the same if other WPS-enabled devices are added later.

Safeguarding Your Network

2-11

v1.0, November 2009

Page 31
Image 31
NETGEAR WNR3500L-100NAS user manual Using a PIN to Configure Your Network and Add a Client