Network Technologies RACKMUX-T15, RACKMUX Series Connect The Cables, Connect a CPU to the Rackmux

NTI RACKMUX RACKMOUNT ANSI TERMINAL DRAWER

1.2 Connect The Cables

1.Connect a female SUB D 9 end of the null modem cable (supplied) to the "SERIAL 1" male SUB D 9 serial interface connector on the RACKMUX (see Fig. 4).

2.Connect the other end of the null modem cable to a CPU.

Alternatively, use an Ethernet cable to connect to a CPU (see Fig. 5). For direct connection, use a crossover cable (see pinout on page 46). For connection through a Local Area Network (LAN), use a patch cable wired straight through (pin 1 to pin 1, pin 2 to pin 2, etc.).

Note: A serial cable (Figure 4) and Ethernet cable cannot both be connected at the same time.

3. Connect the VEXT-1.5-MM cable between the	Attach local printer
ports labeled "MONITOR" and "VGA".
	either by parallel cable to Parallel
	or by serial cable to Serial 2

4.If connecting a printer, connect either a serial printer cable to the remaining male SUB D 9 connector or a parallel printer cable to the female SUB D 25 connector (see page 3, items 19 & 20).

5.Connect the IEC power cord to the IEC connector.

	Rear View
IEC Powercord	RACKMUX-T15
(supplied)	15HD male
	Video Connector
Rear View of CPU	VEXT-1,5-MM (supplied)
	9DF25DM-NUL-6
	(supplied)
	SUB D 9 female
	connector
SUB D 25 male
connector

Figure 4 -Connect a CPU to the RACKMUX

		Rear View
	male RJ45	RACKMUX-T15
Rear View of CPU	connector		Server
	10Base T Ethernet Cable	male RJ45
Server
	(crossover cable)	connector

LAN

10Base T Ethernet

Cable

(patch cable)

Figure 5- Connect to CPU using Ethernet cable

6