NTI RACKMUX RACKMOUNT ANSI TERMINAL DRAWER
Table 2- Programmable Keys
| Enhanced |
|
| Enhanced |
|
|
|
|
| ||
| F1 through F12 |
| ENTER (Both ENTER keys are programmable) | ||
| (UP ARROW) |
| ESCAPE | ||
| (DOWN ARROW) |
| HOME | ||
| (LEFT ARROW) |
| INSERT | ||
| (RIGHT ARROW) |
| PAGE DOWN | ||
| BACKSPACE |
| PAGE UP | ||
| DELETE |
| PRINT SCREEN | ||
| END |
| TAB | ||
F8- Ansbk SET-UP Menu
A message of up to 20 characters can be programmed to identify the terminal to the CPU. Enter the message at the cursor
position. Correct errors by pressing < > (left arrow) to delete characters or <Home> to clear the message. CONCEAL hides the answerback message, so it is not displayed in setup mode.
To save the message in nonvolatile memory, exit Setup mode with the YES option.
F9- Lan Setup Menu
This menu configures the terminal for Ethernet communication. Use of Ethernet communications provides the additional ability to open multiple sessions (applications) on one or more CPUs/servers at the same time. Support of these extended features requires the server to be configured to accept telnet connections.
Note: The Ethernet option in the F4 setup menu must be set to ON for the terminal to work in an Ethernet environment.
Local IP Address is the IP address assigned to this terminal. This must be a unique IP address. An example of this address is 200.200.200.10.
Netmask is a value generated by the system based on the IP address. The system administrator would have this information. An example is 255.255.255.0
Gateway This IP address is used to communicate with other networks. If a gateway is not being used this option should be blank.
Remote IP 0...B Address are for any remote CPU, or devices, that the terminal will communicate with for a specific session. These twelve remote IP addresses should all be identical if all communications will be with only one CPU. If
Note 1: The
Note 2: Port 23 is the telnet service by default.
Note 3: The terminal must be powered cycled after saving for these parameters to take effect.
Term Type allows definition of the terminal with up to 40 characters. If Term Type is empty the default type is sent to the CPU by the system.
Ethernet Node ID displays the serial number of the hardware Ethernet interface device. This is a default value of the manufacturer of the hardware device and should not be changed.
F10- Colr1 Set-up Menu
Selects the color palette to be used for each screen attribute. A text sample of the selected color is displayed next to each selection. Attribute selections are listed below.
Normal | Undl. |
Dim | Undl. Blank |
Blank | Undl. Blink |
Blink | Undl. Blink Blank |
Blink Blank | Undl. Rev |
Rev | Undl. Rev Blank |
Rev Blank | Undl. Rev Blink |
Rev Blink | Undl. Rev Blink Blank |
Rev Blink Blank |
|
12
