252

U

3

Acquire dust off reference data.

Press the shutter-release button the rest of the way down to acquire Image Dust 

Off reference data. The monitor turns off when the shutter-release button is 

pressed. Note that noise reduction will be performed if the subject is poorly lit, 

increasing recording times.

If the reference object is too bright or too dark, the camera 

may be unable to acquire Image Dust Off reference data 

and the message shown at right will be displayed. Choose 

another reference object and repeat the process from 

step 1.

Reduce flicker and banding when shooting under fluorescent or mercury-vapor 

lighting during live view or movie recording. Choose 

Auto

 to allow the camera to 

automatically choose the correct frequency, or manually match the frequency to that 

of the local AC power supply.

D

Image Sensor Cleaning

Dust off reference data recorded before image sensor cleaning is performed can not be used 

with photographs taken after image sensor cleaning is performed. Select 

Clean sensor and 

then start

 only if the dust off reference data will not be used with existing photographs.

D

Image Dust Off Reference Data

The same reference data can be used for photographs taken with 

different lenses or at different apertures. Reference images can not 

be viewed using computer imaging software. A grid pattern is 

displayed when reference images are viewed on the camera.

Flicker Reduction

G

 button

➜

B

setup menu

A

Flicker Reduction

If 

Auto

 fails to produce the desired results and you are unsure as to the frequency of the local 

power supply, test both the 50 and 60 Hz options and choose the one that produces the best 

results. Flicker reduction may not produce the desired results if the subject is very bright, in 

which case you should try choosing a smaller aperture (higher f-number).

Page 278
Image 278
Open full-size image