FILM ADVANCE MODE

++

There are four automatic film advance modes. Hold FUNCTION button and rotate command dial until the Function Area indicator appears in the Film Advance Mode Area and rfl , HQj, s;!!I or sf"l blinks, then hold SET/0 button and rotate command dial until desired symbol appears. Set rfl for single-frame shooting, s;!!I for continuous low-speed shooting, HQj for continuous high -speed shooting, or sf'l for silent rewind, and so on.

ill Single-frame shooting and sf'Dsilent rewind

Fully depressing shutter release button takes one picture and automatically advances film by one frame. Film is advanced immediately after shutter closes whether you remove your finger from shutter release button or keep the button depressed. To take the next shot, lift your finger from the button , then fully depress it again.

sf"l for silent rewind is for times when conditions require a minimum of operating noise. You can rewind film very quietly.

~Continuous low-speed and H~ continuous high-speed shooting

Shots are taken continuously as long as you keep shutter release button fully depressed. You have a choice of shooting speeds: approx. 3.7 fps (frames per second) in the HQj mode, and approx. 2.0 fps in the s;!!I mode-with fresh lithium batteries at normal temperature (20"C or 68"F) and at shutter speeds of 1/250 sec. or higher in the Manual exposure and Manual focus modes. With shutter speeds slower than 1/250 sec., the framing rate becomes progressively slower in proportion to the shutter speed in use.

When built-in flash is activated , continuous shooting is automatically switched over to single-frame shooting (rfl). In this case, HQj or s;!!I blinks in LCD panel.

28

Page 28
Image 28
Nikon N70 Ill Single-frame shooting and sfDsilent rewind, ~ Continuous low-speed and H~ continuous high-speed shooting