Nortel Networks 43W7774 manual Cfg/sys/radius, Radius Server Configuration, Telnet disableenable

Alteon OS Command Reference

/cfg/sys/radius

RADIUS Server Configuration

[RADIUS Server Menu]

prisrv	-	Set primary RADIUS server address
secsrv	-	Set secondary RADIUS server address
secret	-	Set RADIUS secret
secret2	-	Set secondary RADIUS server secret
port	-	Set RADIUS port	retries
retries -		Set RADIUS server
timeout	-	Set RADIUS server	timeout
telnet	-	Enable or disable	RADIUS backdoor for telnet
on	-	Turn RADIUS authentication ON
off	-	Turn RADIUS authentication OFF
cur	-	Display current RADIUS configuration

Table 6-5System Configuration Menu Options (/cfg/sys/radius)

Command Syntax and Usage

prisrv <IP address>

Sets the primary RADIUS server address.

secsrv <IP address>

Sets the secondary RADIUS server address.

secret <1-32 character secret>

This is the shared secret between the switch and the RADIUS server(s).

secret2 <1-32 character secret>

This is the secondary shared secret between the switch and the RADIUS server(s).

port <RADIUS port configure, default 1645>

Enter the number of the UDP port to be configured, between 1500 - 3000. The default is 1645.

retries <RADIUS server retries (1-3)>

Sets the number of failed authentication requests before switching to a different RADIUS server. The default is 3 requests.

timeout <RADIUS server timeout seconds (1-10)>

Sets the amount of time, in seconds, before a RADIUS server authentication attempt is considered to have failed. The default is 3 seconds.

telnet disableenable

Enables or disables the RADIUS backdoor for telnet. The telnet command also applies to SSH/SCP connections and the Browser-Based Interface (BBI). The default is disabled. To obtain the RADIUS backdoor password for your GbESM, contact your IBM Service and Support line.

on

Enables the RADIUS server.

180 „ The Configuration Menu 43W7774, May 2007