Nortel Networks 43W7774 manual Applying Pending Changes, Saving the Configuration, # apply, # save

Alteon OS Command Reference

Applying Pending Changes

To make your configuration changes active, you must apply them. To apply configuration changes, enter apply at any prompt in the CLI.

#apply

NOTE – The apply command is a global command. Therefore, you can enter apply at any prompt in the administrative interface.

Saving the Configuration

In addition to applying the configuration changes, you can save them to flash memory on the GbE Switch Module.

NOTE – If you do not save the changes, they will be lost the next time the system is rebooted.

To save the new configuration, enter the following command at any CLI prompt:

#save

When you save configuration changes, the changes are saved to the active configuration block. The configuration being replaced by the save is first copied to the backup configuration block. If you do not want the previous configuration block copied to the backup configuration block, enter the following instead:

#save n

You can decide which configuration you want to run the next time you reset the switch. Your options include:

„The active configuration block

„The backup configuration block

„Factory default configuration

You can view all pending configuration changes that have been applied but not saved to flash memory using the diff flash command. It is a global command that can be executed from any menu.

For instructions on selecting the configuration to run at the next system reset, see “Selecting a Configuration Block” on page 336.

174 „ The Configuration Menu 43W7774, May 2007