Nortel Networks RTU-292 SW2-8 Full/Half Duplex Off Full Duplex, Baud Rate, Radio Control Mode

RTU-292 Operations Manual

Table 2-7	Full/Half Duplex
SW2-8	Full/Half Duplex
Off	Full Duplex
On	Half Duplex *

2.8.10 SERIAL PORT BAUD RATE

Internal dipswitches SW1-1 and SW1-2 on the Main board configure the RS-232 baud rate of the unit's serial port as shown in the table below. The factory setting is 9600 Baud.

	Table 2-8	Baud Rate
SW1-1	SW1-2		Baud Rate
Off	Off		300
On	Off		1200
Off	On		4800
On	On		9600 *

2.8.11 RADIO CONTROL MODE

Dipswitch SW1-3 enables the RTU-292 to be put into the Radio Control Mode via one of its DTMF commands. In this mode the RTU-292 can be used to relay radio control commands via its RS-232 port to a companion Motorola URC-200 radio. The factory default disables this mode, with SW1-3 set to OFF. See also Tables 3-1 and 3-3.

Table 2-9	Radio Control Mode
SW1-3	Radio Control
Off	Disabled *
On	Enabled

2-9 JPS Communications, Inc.