Nortel Networks RTU-292 Operations Manual, 2 Programming Mode DTMF Commands, Function

RTU-292 Operations Manual

Table 3-2Programming Mode DTMF Commands

These commands may be entered by the RTU-292 front panel keypad*, or by the keypad of a connected telephone or by a telephone set wired to the Local Phone Option. The unit must be put into the programming mode by entering *99 before these commands can be executed. *See 3.7.6 for special instructions regarding the use of the RTU-292 keypad.

DTMF Command	Function
* 0 x	Call Logging Enable/Disable. * 0 0 Disables Call Logging (factory
	default is disabled). * 0 1 Enables Call Logging. See 3. 7.13.

*1 x x x # Change the password to "xxx". Terminate entry with #. Password may be up to 10 digits long. Factory default is 1 2 3 4.

* 2 x	Program the inactivity disconnect timer based on value of "x".
	See 3.7.8 for more information.
	* 2 0	Disabled (not recommended see 3.7.8)
	* 2 1	2 Minutes
	* 2 2	5 Minutes (factory default)
	* 2 3	10	Minutes
	* 2 4	20	Minutes
	* 2 5	30	Minutes
	* 2 6	45	Minutes
	* 2 7	60	Minutes
	* 2 8	90	Minutes
	* 2 9	120 Minutes
* 3x	Program the	Calling Timer based on the value of “x”.
	The RTU-292 will attempt to place a call to a telephone until this timer
	expires. See 3.7.8 for more complete information.
	* 3 0	30	Seconds (factory default)
	* 3 1	1 Minute
* 4xx	Program Speed	Dial Entry “xx”. See 3.7.10.
* 5	Review Speed Dial Entry “xx”.
* 6 x	Select 2 wire or 4 wire operation based on the value of “x”. See 3.7.15

*6 0 2 wire operation (factory default)

*6 1 4 wire operation

*6 # Query to learn current setting

*7 & * 8 Reserved for future use.

* 9	Reserved for JPS Manufacturing
* #	Leave Programming Mode
	3-15	JPS Communications, Inc.