Nortel Networks RTU-292 Operations Manual, Handset/Speaker Interface, Radio Interface

RTU-292 Operations Manual

1.3.1.2 Handset/Speaker Interface

The Handset/Speaker Interface Section contains the speaker pre-amp and driver, the headphone pre-amp and driver. Audio gates controlled by the front panel switches route the audio to the speaker and handset microphone preamplifier and ALC (Automatic Level Control) circuit.

1.3.1.3 Radio Interface

The Radio Interface Section consists of operational amplifier circuits that handle the audio interfaces between the RTU-292 and the radio. The amplifiers provide gain adjustability to accommodate various input and output levels, and also provide impedance transformation and output drive capability. Audio gates controlled by the front panel switches and the CPU route the audio as desired by the operator.

1.3.1.4 DSP Module

The plug-in Digital Signal Processor (DSP) module is the heart of the unit, as the adaptive hybrid is implemented with the DSP. From a hardware standpoint, the DSP section consists of a DSP chip interfaced with dual analog interface ICs, static RAM for audio storage and delay, and a program flash memory IC.

From a software standpoint, the following functions are implemented in software in the DSP section: the adaptive hybrid, the VOX, an audio peak detector, the noise generator for measuring the telephone line characteristics, an audio delay and the transmit setup tone generator.

1.3.1.5 CPU Section

This section contains the microprocessor and program software that controls all operations of the RTU-292. Various I/O devices read external inputs and the front panel controls. The inputs are processed and audio gates, front panel LEDs, audio prompts, etc., are controlled accordingly.

1.3.1.6 Power Supply Section

The power supply in the RTU-292 is a quiet and reliable passive regulator type. It furnishes regulated voltages of +12V, -12V, +5V and -5V to the unit.

1.3.2 FRONT PANEL SWITCH ASSEMBLIES

There are three separate front panel switch assemblies that contain the pushbutton switches and LED indicators for the RTU-292. Each of these assemblies contains a different complement of components as required by its function. Signals from the switches are read by the CPU circuitry on the main board. The processor then routes audio signals and lights the front panel LEDs according to the pushbutton commands.

1.3.3 OPTIONS INTERFACE BOARD

This board, located on the Options Tray above the main board, contains the connectors used to interface the main board to the various option boards that may be assembled to the Options Tray.

1-3 JPS Communications, Inc.