0 2
03ERR REPORT(MCF): This function automatically prints a Message Confirmation Report each time an error occurs during a transmission or polling transmission operation. The report provides information about the
04IMAGE IN MCF: When a message confirmation of a memory transmission is printed, this function adds a portion of the first page of the document that was sent. This feature makes it easier to identify a fax, but it may present security problems if you are sending sensitive documents. Available settings are ON (default) and OFF.
05SENDER ID: This function controls the printing of your OKIFAX’s Sender ID on the faxes you send. See page 23 for details. When turned on, the Sender ID will be printed on each page slightly outside the image area of your document. The default setting is ON.
Note: In order to meet FCC requirements, you must have this feature set to ON and have a valid Sender ID programmed in your OKIFAX.
06MONITOR VOLUME: This function sets the volume for telephone line monitoring during dialing. Avail- able settings are LOW (default), HIGH, and OFF.
07BUZZER VOLUME: This function sets the volume of the various tones your OKIFAX emits during opera- tion. Available settings are LOW, MIDDLE (default), and HIGH.
08CLOSED NETWORK: This function allows you to pro- gram your OKIFAX to refuse to communicate with locations whose telephone numbers have not been programmed into your One Touch keys or Auto Dial locations. Using this function, you can set up a closed network of fax
09TX MODE DEFAULT: Your OKIFAX is set for the STD (standard) resolution setting and the NORMAL contrast setting. If you consistently send faxes that require some other combination of transmission modes, use this function setting to change the default modes. While you are programming, the new default combinations appear on the lights above the Yes § and the No © keys. The default is
STD/NORMAL.
56Customizing