board engage the connector, then make sure the white tabs come up to lock the module in place.
4.Replace the main board and secure it with the two screws.
5.Reconnect the printer interface cable and power cable, then switch on the printer.
NOTE
If the error message SERVICE CALL/034 appears on the LCD after switching the printer on, turn the printer off and pull the main board back out and make sure the memory modules have been installed correctly.
6.Print a MenuMap (see “Printing the MenuMap” on page 35) and check that the Total Memory Size shown at the top of the MenuMap matches the memory now installed in the printer. If it doesn’t, turn the printer off and pull out the main board and check to be sure that the modules are all firmly seated in their connectors.
7.In the printer driver(s), change the installed memory to match the new value:
–For Windows XP: see page 78
–For Windows 2000: see page 150
–For Windows Me/98/95 (PostScript driver only): see page 217
–For Windows NT 4.0: see page 282
