WIRELESS COMMUNICATION (continued)

Radio Power Output:

100 mW (20 dBm), 10 mW (10 dBm)

 

 

 

Limitations on Equivalent Isotropic Radiated Power (EIRP) levels in the

 

 

 

European Community and other countries applies. An improper combination of

 

 

 

 

 

 

 

 

 

power level can result in an EIRP above the allowed amount per regulations.

 

 

 

See

Appendix F.

Bit rate 250 Kp/s; Symbol rate 62.5 Symbol/s; Chip rate 2000

Data Rate:

 

Modulation:

 

kchip/s

 

 

 

Orthogonal Quaternary Phase Shift Keying (O-QPSK)

Meter/Receiver Sensitivity:

-100 dBm

 

 

Range:

 

The range depends on the specific Connector/Transmitter

 

 

 

 

 

used. Refer to the

UWTC Manual for more specifications.

 

 

 

The range assume a Line-of-Sight (LOS) between the Meter/Receiver and

 

 

 

Connector/Transmitter without obstructions or interference at which the

 

 

 

 

 

 

 

diagnostic signal strength web interface registers approximately 25%.

Antenna Frequency:

2400 to 2500 Mhz

 

 

Impedance:

 

50 ohm

 

 

Connector:

 

Reverse Polarity SMA Plug

SAFETY & REGULATORY COMPLIANCE

Safety:

EN 61010-1:2001

 

 

EMC:

Safety requirements article 3.1.a of the R&TTE

EN 301 489-1 V1.6.1:2005-09

 

 

 

 

Electromagnetic compatibility article 3.1.b of the R&TTE

 

 

 

 

EN 301 489-17 V1.2.1:2002-08

 

 

 

 

Electromagnetic compatibility article 3.1.b of the R&TTE

Radio:

EN 55022:2006 + A1:2007, Class A, (CISPR 22 +A1:2005)

EN 300 328 V1.7.1:2006-10 Spectrum article 3(2) of the R&TTE

FCC:

Part 15C, Class DTS Intentional radiator tested for 15.205, 15.209,

 

 

 

 

15.247(d), 15.215(c), 15.247(a)(2), 15.247(b), 15.247(e).

 

 

 

 

See Appendix F.

 

 

 

 

 

 

This device complies with part 15 of the FCC Rules. Operation is subject

 

 

 

 

to the following two conditions: (1) This device may not cause harmful

 

 

 

 

interference, and (2) this device must accept any interference received,

CE:

including interference that may cause undesired operation.

The product herewith complies with the essential requirements and other

 

 

 

 

relevant provisions of the R&TTE Directive 1999/5/EC, the EMC

 

 

 

 

Directive 2004/108/EC, and the Low Voltage Directive 2006/95/EC, and

 

 

 

 

carries the CE-marking accordingly.

 

 

 

 

The following CE Mark

 

 

 

 

is affixed to this equipment.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

See Appendix F. The CE declaration is available at the website listed

 

 

 

 

on the cover page of this manual.

73

Page 79
Image 79
Omega WI8XX-U manual Safety & Regulatory Compliance