4.3.9.1 End Device Parameters (continued) | ||
If the end character for instance is 20 (Hex representation of space), the data will | ||
then appear as: T75F T74F |
| |
If nothing is set for the "Remote End Char" field, the Meter will then forward the | ||
data to the LAN with no characters followed. | ||
Offset: If it’s determined that the readings are slightly off, the user can manually | ||
assign numerical values to adjust the readings for temperature. The unit must be | ||
in degree C. |
| |
Display: | To enable or disable numerical display on the Meter’s Front Panel. By | |
default, the box is checked (enabled). |
| |
Alarm: To enable or disable alarms for that particular sensor. By default, the box | ||
is checked (enabled). |
| |
Sensor 2 |
| |
This is the field to modify the parameters for the ambient sensor. | ||
Update: | Saves changes. |
|
Cancel: | Ignores all the changes and goes back to the "End Device Setup" page. | |
Reset Device: Reset the End Device’s readings and status. Its data will be | ||
cleared immediately. |
| |
4.3.10 Access Control |
| |
This section describes the "Access Control" page of the Wireless System Web | ||
interface. This page allows the users to set up the network and security | ||
parameters of the Wireless System. |
| |
At the initial entrance to the "Access Control" page you may be prompted for the | ||
LOGIN Password (see Figure 4.6) prior to an ADMINISTRATOR Password. | ||
| ACCESS CONTROL |
|
| Address http://192.168.1.200 |
|
| ACCESS CONTROL | |
| Login Password | 12345678 |
| Admin Password | 00000000 |
| Host Name wis21d9 | |
| MAC Address 00:03:03:00:21:D9 | |
| IP Address 192.168.1.200 | |
| Gateway Address | 0.0.0.0 |
| Subnet Mask 255.255.255.0 | |
| Save | Reset |
Network Reset
Main Menu
Figure 4.25 Access Control
55
