Omega Speaker Systems FPU5-MT-110 See .2 to set the pumping direction, 11.Closing the Stator

Getting Started 3

Figure 3-11. Closing the Stator Figure 3-12. Adjusting the Clamp Screw

1.Refer to Figure 3-8 and Figure 3-9. Snap open the Stator by pushing the spring-loaded area of the Latch. Remove any old tubing from the pump, if necessary.

2.Refer to Figure 3-8 and Figure 3-10. Loop the Tubing over the rollers. This is easy to do even for stacked pumps.

NOTE

Tubing can be changed on stacked pumps without detaching either of the pumps from the motor.

3.Refer to Figure 3-11. Push the Stator closed until you hear the Latch engage.

4.Refer to Figure 3-12. Tighten the Clamp Screw until the Clamp Plate contacts the Tubing, securing it in place.

5.Set up the source and drain containers so that the tubing inlet is immersed in the fluid in the source container and the tubing outlet is in the drain container.

NOTE

See Section 5.2 to set the pumping direction.

3-5