Omega Speaker Systems FPU5-MT-110 Turning on the Power, Introduction to the Two Display Modes

4 Turning on the Power

4.1 Introduction to the Two Display Modes

The pump motor has two modes of operation defined by whether or not the motor is running. Refer to Table 4-1. These two modes are known as the STOPPED Display Mode and the RUNNING Display Mode.

	Table 4-1. STOPPED vs. RUNNING Display Modes
Condition	Status During	Status During
	Stopped Display Mode	Running Display Mode
ON/OFF Switch	ON	ON
Motor	STOPPED	RUNNING
Pump	STOPPED	RUNNING
Display	FLASHING	NOT FLASHING
Green LEDs	NOT FLASHING	FLASHING
Fluid	NOT FLOWING	FLOWING

4.2 Using the ON/OFF Switch

When the ON/OFF switch is pushed upwards the unit’s power is on. When the switch is pushed downward, the unit’s power is off and the top of the switch labeled “0” is visible.

4.3 The STOPPED Display Mode

To enter the STOPPED Display Mode, do the following:

1.Plug in the pump motor to a convenient ac wall outlet. Use ac power within the range of 90 to 130 Vac (for 115 Vac units) or 190 to 260 Vac (for 220 Vac units).

NOTE

A line filter is already installed in the pump motor.

2.Attach the pump(s). Refer to Section 3.1.

4-1