5Operating the Pump Motor in the STOPPED Display Mode
INLET SELECT | RPM | TIME | INLET SELECT | |
| LEFT PUMP | RIGHT PUMP | ||
INLET |
| FLOW | TOTAL | PRIME |
SELECT |
| RATE | VOLUME |
|
TEMP |
| TUBE ID | CALIBRATE | START |
|
|
| STOP | |
MOTOR TURNING | MOTOR TURNING | |||
CLOCKWISE | ||||
|
| INLET |
| OUTLET |
|
| OUTLET |
| INLET |
Left Pump | Right Pump | |||
| INLET SELECT | RPM | TIME | INLET SELECT |
| LEFT PUMP | RIGHT PUMP | ||
|
|
| ||
INLET |
| FLOW | TOTAL | PRIME |
SELECT |
| RATE | VOLUME | |
|
| |||
TEMP |
| TUBE ID | CALIBRATE | START |
|
| STOP | ||
|
|
|
| |
MOTOR TURNING | MOTOR TURNING | |||
| CLOCKWISE | |||
|
| OUTLET |
| INLET |
|
| INLET |
| OUTLET |
|
|
|
| |
Left Pump | Right Pump |
Figure 5-1. Defining the Direction of Pumping
3.To change the direction of pumping, press the INLET SELECT key. The lit, green LEDs change positions. Fluid flows in the opposite direction.
4.To change back to the original direction of pumping, simply press the INLET SELECT key again.
5.3Selecting the Tubing Inner Diameter
The TUBE ID, and UP and DOWN ARROW keys allow you to select the inner diameter of the tubing.
NOTE
With the peristaltic pump motor, you can either select a tubing size from those shown in the display (using the TUBE ID key), or you can calibrate each piece of tubing you use (using the CALIBRATE key, as described in Section 5.5).