Onkyo TX-NR900E instruction manual Connecting to Audio/Video equipment, Signal flow

Connecting to Audio/Video equipment

Digital audio input (optical) : Signal flow

Digital audio output (coaxial)
S Video input
Video input
Analog audio	R (red)
input
	L (white)

7.DVD recorder, other digital video recording device (VIDEO 2)

	R (red)
Analog audio
output	L (white)
Video output
S Video output	Y
	PB

DIGITAL		PR	AUDIO	VIDEO	S VIDEO	COMPONENT
INPUT		RENNA				VIDEO
COAX	FRONT				MONITOR	OUTPUT
1					OUT	Y
			R	L
	SUB
2			AM	OUT	ZONE 2	PB
	SURR
3				IN	DVD	PR
	SURR	R
OPT	BACK/					INPUT 1
	ZONE 2
			FM
1				OUT		Y
			75
					VIDEO 1
2	FRONT			IN		PB
		DIO
	R
		L
	SUB
3			PHONO	OUT		PR
	SURR				VIDEO 2	INPUT 2
4			CD	IN		Y
OPT		R	OUT
1	SURR			IN	VIDEO 3	PB
	BACK		TAPE
2				IN	VIDEO 4	PR
	GND		IN	L
		L	R
DIGITAL		DIO	AUDIO	VIDEO	S VIDEO
OUTPUT

Component video output

PR

7.Connecting a DVD recorder or other digital video recording device (VIDEO 2)

Using RCA video cables, connect the video output jack (composite) of the device to the VIDEO 2 VIDEO IN jack of the TX-NR900/ 900E and connect the video input jack of the device to the VIDEO 2 VIDEO OUT jack of the TX-NR900/900E. Or if the device has S video input and output jacks, connect them to the VIDEO 2 S VIDEO IN and OUT jacks of the TX-NR900/900E using S video cables. Or if the device has component video outputs, connect them to one of the banks of COMPONENT VIDEO INPUT jacks on the TX-NR900/900E.

With the initial settings of the TX-NR900/900E, the VIDEO 2 input source is set for the COMPONENT VIDEO INPUT 2 jacks.

If you connect the device to the COMPONENT VIDEO INPUT 1 jacks, this must be changed at Setup Menu → Input Setup → Video Setup → Component Video (see page 53).

Using RCA audio cables, connect the audio output jacks of the device to the VIDEO 2 AUDIO IN jacks of the TX-NR900/900E and connect the audio input jacks of the device to the VIDEO 2 AUDIO OUT jacks of the TX-NR900/900E. Make sure that you properly connect the left channels to the L jacks and the right channels to the R jacks.

If the device has a digital output, connect it to either the DIGITAL INPUT COAX jack or DIGITAL INPUT OPT jack of the TX- NR900/900E depending on the type of connector on the device.

With the initial settings of the TX-NR900/900E, the VIDEO 2 input source is set for digital input at the COAX 3 jack.

If the digital connection is made at a different jack, this must be changed at Setup Menu → Input Setup → Digital Setup (see page 51).

If the device has a digital input, connect it to the DIGITAL OUTPUT OPT jack of the TX-NR900/900E for digital recording of the REC OUT signal from the TX-NR900/900E.

Note:

The output from the DIGITAL OUTPUT jack of the TX-NR900/ 900E is only the digital signal input to the DIGITAL INPUT jack.

20