Operating components not reached by the remote controller signals (IR IN/OUT)
In order to use the remote controller to control the
•Onkyo’s
•Multiroom A/V distribution and control system such as those from Niles® and Xantech®
If the remote controller signal does not reach the
If the
With this connection, select “Main” for the Hardware Setup → IR IN Setup → Position setting in the Setup Menu (see page 47).
Connecting | IR Receiver |
block
IR IN
Remote controller
In the cabinet
: Signal flow
The IR IN input allows you to control the
With this connection, select “Zone 2” for the Hardware Setup → IR IN Setup → Position setting in the Setup Menu (see page 47).
To IR IN
IR Receiver
900E Connecting
block
Remote controller
Main room | Zone 2 room |
: Signal flow
Make the connection as shown below. Do not plug in any equipment to the power outlet until all the connections are complete.
from connecting block
Mini plug cable
I R
IN
OUT
If the remote controller signal does not reach other components
In this situation, you will need to use a commercially available IR emitter. Connect the mini plug of the IR emitter to the IR OUT terminal on the
| Connecting | IR Receiver |
IR IN | block |
|
|
| |
|
| |
IR OUT | 900E |
|
| IR Emitter |
|
| Remote controller | |
Other |
|
|
component |
|
|
|
| : Signal flow |
| Other component | |
: Signal flow | Remote control | |
|
| |
|
| sensor |
I R |
| Emitter |
IN |
| |
Mini plug | Mini plug cable | |
OUT |
| |
IR Emitter |
|
27