Labeling Buttons and Menu Items, Labeling a button | Onkyo USR-5RF

Getting the Maximum out of it

3.Labeling Buttons and Menu Items

The following elements can be labeled: control panel buttons, Device menu items, macros, macro groups and Left/Right buttons.

You cannot label Home menu buttons directly. You have to label them by using the Device menu (see page 26).

4.Edit the label.

•To delete a character, press the Right button.

•To enter a character, tap the keyboard near the character you want to use. The keyboard is zoomed in, allowing you to tap exactly the character you need.

Labeling a button

1.Navigate to the panel containing the button you want to label.

2.Switch to Label mode by using the

Mode button .

3. Tap the button you want to label.

The display shows a “virtual auto-zooming” mini-keyboard. The button you want to label is displayed above the keyboard.

After you have tapped the character, the keyboard is zoomed out. Repeat this action for every character.

Note:

You can zoom out again without tapping a character by pressing the Right button (labeled Zoom).

• For capital letters and symbols, press the Left button repeatedly to display the keyboard you want.

25

Image 25

Onkyo USR-5RF instruction manual Labeling Buttons and Menu Items, Labeling a button, Edit the label

Contents

USR-5RF Care Precautions Table of contents Insert batteries Quick StartTouch the screen to start Operate your components Quick reference Quick reference Modes Quick reference Direct-access buttons Intelligent Remote ControllerIntroduction Touchscreen buttons Left and Right buttonsWhich Buttons Can Be Programmed? AA batteries Charging the Remote Controller Optional recharging dock Getting Started Activate the remote controllerDefine the Brand of Your Device Select Yes to define the brand of the device to operate Defining brands by selectingTap Next Select your brand from the list Navigate through the list of brands Select a code set from the list Tap Search Defining brands by searching Via the Home menu Select a DeviceVia the Device menu Sending commands Using touchscreen buttonsOperate a Device Scrolling IR commands Device pages Touch and hold the remote controller icon for a few seconds Adjust the SettingsTap the button of the setting you want to adjust Use the Left and Right button to adjust the setting Third setup panel Second setup panel Introduction Getting the Maximum out of itWorking with Modes To hide the Mode menu Tap the mode you want to useTap Programming control panel buttons Programming Buttons Programming device items Programming direct-access and Left/Right ButtonsMake sure the device tab is active Labeling a button Labeling Buttons and Menu ItemsEdit the label Complete instruction 4 to 6 Labeling a button on Labeling a menu item Adding devices Adding and Moving DevicesMoving menu items Delete Delete and restoreDeleting a button or button function Tap the item you want to restore Restore Recording macros Recording Macros and Setting Timers Editing macros Setting timers Organizing macros and timers into groups Editing timersEdit the timer Press the Left button to close the timer Tap Create Timer Group or Create Macro Group Using the remote controller with Radio Frequency Switch to RF IR mode by using Mode button Changing the remote controller’s RF IR SettingsTap RF Changing the Extender ID Try the devices which you just changed the RF IR settings Select a device that is set with RF signals Switch back to RF IR modeChoosing Another Channel Press the + and action buttons to change the Channel With ChadEdit you can ChadEdit System requirements General Problems Programming Problems Troubleshooting Recharging Problems How do I program source switching? Can I program a button to execute more than one command?How do I reset the Remote controller? How do I revert to the original configuration? Overview of Symbols Specifications Onkyo U.S.A. Corporation