Getting the Maximum out of it
2. Programming Buttons
You program the remote controller commands by transmitting infrared signals from your existing remote controls to the remote controller’s learning eye. To do this, place the remote controller and the device’s remote controller on a flat surface, 15 to 20 cm (6 to 8 inches) apart.
15 to 20 cm (6 to 8 inches)
The following buttons can be programmed: control panel buttons, Device menu items, direct- access buttons and Left/Right buttons.
You cannot program Home menu buttons directly. You need to program them by following the Device menu (see page 24).
The remote controller also offers empty control panel buttons you can program and label as existing buttons. They are only visible in Learn and Label mode and appear without label or with label (intended for a specific function). You will also see previously deleted buttons: you can restore them by reprogramming them or you can reuse them for other commands.
Programming control panel buttons
1.Navigate to the control panel buttons you want to program.
2.Switch to Learn mode by using the Mode button.
Additional empty buttons appear: they can be programmed and labeled as existing buttons.
3.Point the device’s original remote controller to the remote controller’s learning eye as shown (see above).
4.Tap the remote controller button you want to program.
The button starts blinking.
5.Press and hold the corresponding button on your device’s original remote controller.
If the remote controller has learned the command successfully, OK blinks on the remote controller icon. You can let go of the button you’re holding.
If the remote controller has not learned the command successfully, you hear a short buzz and FAIL appears on the remote controller icon.
6.Program all other buttons you want and relabel them as necessary (see page 25).
7.Return to Use mode by using the Mode button.
23
