Onkyo USR-5RF Programming device items, Programming direct-access and Left/Right Buttons

Getting the Maximum out of it

Programming device items

Note:

When you program a command to a device item, this command is automatically assigned to the corresponding button in the Home menu.

1.Make sure the device tab is active.

The device tab is active when the name of a device is displayed.

2.Switch to Learn mode by using the Mode button.

3.Point the device’s original remote controller to the remote controller’s learning eye as described above.

4.Tap the device tab to open the Device menu.

5.Touch and hold either the remote controller’s Left or Right button and tap the device you want to program.

Even when you want to program the currently active device, you have to tap it in the Device menu.

The label device starts blinking on the remote controller icon.

6.Press and hold the button the remote controller has to learn on your device’s original remote controller.

If the remote controller has been input the command successfully, OK will blink on the display. You can release the button you’re holding.

If the remote controller has not learned the command successfully, you hear a short buzz and FAIL appears on the remote controller icon.

7.Program all other items you want and return to Use mode via the Mode button.

Programming direct-access and Left/Right Buttons

Direct-access and Left/Right buttons can be programmed with a global function or with functions per device. Buttons with global functions always execute the same command, even if device is active. Buttons with functions per device execute commands depending on the active device. For example, the Left button is the Play command when the VCR is active.

Note:

Per-device functions overrule global functions. For example, when you program the Volume buttons globally but you assign a specific function to them with the tuner, the specific command will be executed when the tuner is the active device.

Programming a button globally

1.Tap the Home menu button .

2.Complete steps 2 to 7 in

“Programming control panel buttons” on page 23. Instead of tapping a button on the touchscreen, press the button you want to program.

The label of the button you have pressed (e.g. chan+ or left) starts blinking on the remote controller icon.

Programming a button per device

1.Switch to the device for which you want to program the button.

2.Complete instructions 2 to 7 in

“Programming control panel buttons” on page 23. Instead of tapping a button on the touchscreen, press the button you want to program.

The label of the button you have pressed (e.g. chan+ or left) starts blinking on the remote controller icon.

24