Getting the Maximum out of it
Editing macros
You can edit any macro you have recorded.
1.Open the macro group that contains the macro.
2.Switch to Edit mode via the Mode button.
3.Tap the macro you want to edit.
The contents of the macro appear.
4.Edit the macro.
You can move or delete listed commands or you can add new commands. You can also add delays to the macro (for example, to insert a short pause between turning on a device and sending commands to it allowing the device to warm up):
1.Tap Delay.
2.Tap 
or 
to decrease or increase the length of the delay.
3.Use the arrow buttons 
and 
to move the delay to the right place.
5.Press the Left button to close the macro.
A confirmation screen appears, which allows you to save or cancel the macro.
6.Tap Save.
The macro is ready to be used.
Setting timers
To activate a device at the time you set.
1.Tap the Macro menu button.
2.Open the macro menu and select a timer group.
3.Switch to Edit mode by using the Mode button.
Empty timer buttons appear in the timer control panel.
4.Tap the button you want to set a timer for.
The first timer control panel appears in which you can set the start time.
5.Enter the command the timer has to execute.
A timer can contain either a single IR command or a macro.
You can navigate to any control panel you want, just as you can in Use mode.
31
