Quick reference

5. Panel number

Shows what panel you’re seeing.

–

CONT

LIGHT

MUTE

–

VOL

6. Left and Right buttons

Activate the commands shown immediately above the buttons

7. Scroll button

Display next Control Panel. Scroll buttons may appear on left.

8. Mode menu

Customize the remote controller (see below)

1.Sending eye (IR transmitter)/Learning eye

Send commands to devices

For learning commands from other remote controllers

2. Home

Easy access to all components

3. Macro menu

Execute stored lists of commands

4. Control panel

Tap buttons to send commands to components

9. Device menu

Open a component’s control panels

10. Scroll button

Display previous control panel

11. Remote controller icon

Press and hold for 3 seconds to go to Setup

Page 5

Image 5

Onkyo USR-5RF instruction manual Quick reference

Contents

USR-5RF Care Precautions Table of contents Insert batteries Quick StartTouch the screen to start Operate your components Quick reference Quick reference Modes Quick reference Introduction Intelligent Remote ControllerDirect-access buttons Which Buttons Can Be Programmed? Left and Right buttonsTouchscreen buttons AA batteries Charging the Remote Controller Optional recharging dock Define the Brand of Your Device Activate the remote controllerGetting Started Tap Next Defining brands by selectingSelect Yes to define the brand of the device to operate Select your brand from the list Navigate through the list of brands Select a code set from the list Tap Search Defining brands by searching Via the Device menu Select a DeviceVia the Home menu Sending commands Using touchscreen buttonsOperate a Device Scrolling IR commands Device pages Touch and hold the remote controller icon for a few seconds Adjust the SettingsTap the button of the setting you want to adjust Use the Left and Right button to adjust the setting Third setup panel Second setup panel Working with Modes Getting the Maximum out of itIntroduction Tap Tap the mode you want to useTo hide the Mode menu Programming control panel buttons Programming Buttons Make sure the device tab is active Programming direct-access and Left/Right ButtonsProgramming device items Edit the label Labeling Buttons and Menu ItemsLabeling a button Complete instruction 4 to 6 Labeling a button on Labeling a menu item Moving menu items Adding and Moving DevicesAdding devices Deleting a button or button function Delete and restoreDelete Tap the item you want to restore Restore Recording macros Recording Macros and Setting Timers Editing macros Setting timers Organizing macros and timers into groups Editing timersEdit the timer Press the Left button to close the timer Tap Create Timer Group or Create Macro Group Using the remote controller with Radio Frequency Tap RF Changing the remote controller’s RF IR SettingsSwitch to RF IR mode by using Mode button Changing the Extender ID Try the devices which you just changed the RF IR settings Select a device that is set with RF signals Switch back to RF IR modeChoosing Another Channel Press the + and action buttons to change the Channel With ChadEdit you can ChadEdit System requirements General Problems Programming Problems Troubleshooting Recharging Problems How do I program source switching? Can I program a button to execute more than one command?How do I reset the Remote controller? How do I revert to the original configuration? Overview of Symbols Specifications Onkyo U.S.A. Corporation