Charging the Remote Controller, AA batteries | Onkyo USR-5RF

Introduction

2.Charging the Remote Controller

AAbatteries

1.Slide the battery cover off the back of the remote controller.

2.Insert 4 AA batteries (included in package) as indicated on the bottom of the battery compartment.

3.Slide the battery cover back on.

After a few seconds, the remote controller starts up automatically and beeps twice to indicate that it is ready to use.

When batteries are running low, the Low Battery

icon blinks at the center top of the display. Replace the batteries as soon as possible to ensure perfect performance.

Note:

The remote controller retains all settings when batteries have run out or when you replace them. You will only have to reset the clock.

9

Image 9

Onkyo USR-5RF instruction manual Charging the Remote Controller, AA batteries

Contents

USR-5RF Care Precautions Table of contents Insert batteries Quick StartTouch the screen to start Operate your components Quick reference Quick reference Modes Quick reference Intelligent Remote Controller Direct-access buttonsIntroduction Left and Right buttons Touchscreen buttonsWhich Buttons Can Be Programmed? AA batteries Charging the Remote Controller Optional recharging dock Activate the remote controller Getting StartedDefine the Brand of Your Device Defining brands by selecting Select Yes to define the brand of the device to operateTap Next Select your brand from the list Navigate through the list of brands Select a code set from the list Tap Search Defining brands by searching Select a Device Via the Home menuVia the Device menu Sending commands Using touchscreen buttonsOperate a Device Scrolling IR commands Device pages Touch and hold the remote controller icon for a few seconds Adjust the SettingsTap the button of the setting you want to adjust Use the Left and Right button to adjust the setting Third setup panel Second setup panel Getting the Maximum out of it IntroductionWorking with Modes Tap the mode you want to use To hide the Mode menuTap Programming control panel buttons Programming Buttons Programming direct-access and Left/Right Buttons Programming device itemsMake sure the device tab is active Labeling Buttons and Menu Items Labeling a buttonEdit the label Complete instruction 4 to 6 Labeling a button on Labeling a menu item Adding and Moving Devices Adding devicesMoving menu items Delete and restore DeleteDeleting a button or button function Tap the item you want to restore Restore Recording macros Recording Macros and Setting Timers Editing macros Setting timers Organizing macros and timers into groups Editing timersEdit the timer Press the Left button to close the timer Tap Create Timer Group or Create Macro Group Using the remote controller with Radio Frequency Changing the remote controller’s RF IR Settings Switch to RF IR mode by using Mode buttonTap RF Changing the Extender ID Try the devices which you just changed the RF IR settings Select a device that is set with RF signals Switch back to RF IR modeChoosing Another Channel Press the + and action buttons to change the Channel With ChadEdit you can ChadEdit System requirements General Problems Programming Problems Troubleshooting Recharging Problems How do I program source switching? Can I program a button to execute more than one command?How do I reset the Remote controller? How do I revert to the original configuration? Overview of Symbols Specifications Onkyo U.S.A. Corporation